Installation guide

DigitalMedia 8G+™ Transmitter 200 Crestron DM-TX-200-C-2G-FLOOR/WALL
Floor Box/Electrical Box Mount Design
The DM-TX-200-C-2G-FLOOR is designed to fit a 2-gang opening in a 6 inch (153
mm) deep floor box. The DM-TX-200-C-2G-WALL is designed to be mounted in a
2-gang electrical box (not included), and features an integral metal faceplate.
A DM cable connects to the rear of the DM-TX-200-C-2G via a shielded RJ-45 DM
port. The unit can be powered using the included wall mount power pack or via
Power over DM (PoDM) for a true one-wire solution.* An array of indicators on the
front of the DM-TX-200-C-2G provides for easy setup and troubleshooting.
Advanced configuration is enabled through Crestron Toolbox software.
* PoDM requires connection to a DM 8G+ PoDM power sourcing device.
Application
The following diagram shows a DM-TX-200-C-2G in a standalone application.
In this type of application, the DM-TX-200-C-2G is used with a DM 8G+
receiver/room controller such as the DM-RMC-100-C and is not used with a
DM switcher.
DM-TX-200-C-2G in a Standalone Application (DM-TX-200-C-2G-FLOOR Shown)
4 • DigitalMedia 8G+™ Transmitter 200: DM-TX-200-C-2G-FLOOR/WALL Operations & Installation Guide – DOC. 7255B