Installation guide

DigitalMedia 8G+™ Transmitter 200 Crestron DM-TX-200-C-2G-FLOOR/WALL
NOTE: Either the included 24 VDC power pack or PoDM—but not both—can be
used to power the DM-TX-200-C-2G.
NOTE: Ensure that the unit is properly grounded by connecting the chassis ground
lug to an earth ground (building steel).
NOTE: For DM 8G+ wiring up to 330 feet (100 meters) between devices, use
Crestron DM-CBL-8G DigitalMedia 8G cable, Crestron DM-CBL DigitalMedia
cable, Crestron DM-CBL-D DigitalMedia D cable, or generic CAT5e (or better)
UTP or STP. Shielded cable and connectors are recommended to safeguard against
unpredictable environmental electrical noise which may impact performance at
resolutions above 1080p. Refer to the latest version of the Crestron DigitalMedia
Infrastructure Guide (Doc. 4556) for complete wiring guidelines and to the Crestron
DigitalMedia Design Guide (Doc. 4789) for complete system design guidelines.
22 • DigitalMedia 8G+™ Transmitter 200: DM-TX-200-C-2G-FLOOR/WALL Operations & Installation Guide – DOC. 7255B