Installation guide

DigitalMedia 8G+™ Transmitter 200 Crestron DM-TX-200-C-2G-FLOOR/WALL
DM-TX-200-C-2G-WALL
Installation
The DM-TX-200-C-2G-WALL installs in a 2-gang electrical box (not included) in
an insulated wall, floor, or ceiling. A minimum mounting depth of 2.5 inches
(64 mm) is required.
NOTE: Before installing the DM-TX-200-C-2G-WALL in an electrical box, verify
that the required wiring has been fed through the electrical box. Connect the wiring
to the rear of the DM-TX-200-C-2G-WALL (refer to “Hardware Hookup” on page
21 for information about connections to the rear of the DM-TX-200-C-2G-WALL).
To install the DM-TX-200-C-2G-WALL in an electrical box, do the following (refer
to the illustration below):
1. Using a Phillips head or straight blade screwdriver, attach the
DM-TX-200-C-2G-WALL to the electrical box using the four included
#6-32 x 3/4” truss combo head screws (2009211).
2. Attach the included black faceplate (2032185) or the included white
faceplace (2032202) to the front panel of the DM-TX-200-C-2G-WALL.
DM-TX-200-C-2G-WALL Installation in an Electrical Box
Front Panel
Faceplate,
Black (2032185)
or
Front Panel
Faceplate,
White (2032202)
(Both Included)
#6-32 x 3/4”
Truss Combo
Head Screws (4)
(2009211)
DM-TX-200-C-2G-WALL
(6505711)
2-Gang Electrical Box
(Not Included)
20 • DigitalMedia 8G+™ Transmitter 200: DM-TX-200-C-2G-FLOOR/WALL Operations & Installation Guide – DOC. 7255B