Installation guide

Crestron DM-RMC-200-S/S2 DigitalMedia 8G Fiber Receiver 200

DigitalMedia 8G Fiber Receiver

& Room Controller 200:

DM-RMC-200-S/DM-RMC-200-S2

Introduction

The DM-RMC-200-S/DM-RMC-200-S2, hereinafter referred to simply as the DM

receiver unless otherwise indicated, provides an advanced one-box interface solution

for a single display device as part of a complete Crestron

DigitalMedia™ system.

It functions as a DM 8G

(DM-RMC-200-S)/DM 8G SM (DM-RMC-200-S2) fiber

receiver, video scaler, audio amplifier, and control interface, providing a single

HDMI

output along with speaker and line level audio plus Ethernet, USB HID, and

a variety of control ports. Built-in scaling enables the connected display to handle

virtually any video signal. A compact, low-profile design allows the DM receiver to

be installed discreetly behind a flat panel display or above a ceiling mounted

projector. It connects to the head end or source location using one multimode

(DM-RMC-200-S) or single-mode (DM-RMC-200-S2) fiber strand.

Features and Functions

 DigitalMedia 8G™ multimode (DM-RMC-200-S)/single-mode

(DM-RMC-200-S2) fiber receiver, high-definition scaler, audio

amplifier, and display controller

 DM 8G fiber input supports up to 1000 foot (~300 meter) cable length

(DM-RMC-200-S)

 DM 8G SM fiber input supports up to 7.5 miles (12 km) cable length

(DM-RMC-200-S2)

 Connects to a DM switcher or transmitter (each sold separately) over one

multimode (DM-RMC-200-S)/single-mode (DM-RMC-200-S2)

fiber strand

 Provides one HDMI or DVI display output

 Accepts any video source from standard NTSC 480i or PAL 576i to

HD 1080p60 with Deep Color

(Continued on following page)

1. For DM 8G wiring, the maximum DigitalMedia 8G fiber cable length is 1000 feet (~300 meters)

using CRESFIBER8G fiber optic cable, or 500 feet (~150 meters) using standard CRESFIBER,

CRESFIBER-SINGLE-SC, or generic OM3 simplex multimode fiber optic cable. For DM 8G SMF

wiring up to 7.5 miles (12 km) between devices, use Crestron CRESFIBER8G-SM or generic

G.652.D (or better) single-mode fiber optic cable. Refer to the latest version of the Crestron

DigitalMedia Design Guide (Doc. 4546) for complete system design guidelines. The manual is

available from the Crestron Web site at www.crestron.com/dmresources

. All wire and cables sold

separately.

2. HDMI requires an appropriate adapter or interface cable to accommodate a DVI signal.

CBL-HD-DVI interface cable sold separately.

Operations & Installation Guide – DOC. 7246B DigitalMedia 8G Fiber Receiver 200: DM-RMC-200-S/S2  1