Specifications

Crestron DM-MD8X8/16X16/32X32 DigitalMedia Switchers
Operations Guide DOC. 6755D DigitalMedia Switchers: DM-MD8X8/16X16/32X32
57
b. Press the soft button labeled DONE to return to the Commission
System section.
Data Rate Check
The switcher can test the cable run on each output to determine the maximum data
rate that can be delivered. To run a data rate check:
1. Open the Commission System section as described on page 54.
2. Turn the selection knob to highlight Data Rate Check and press the
ENTER button. A screen showing available cable types will be displayed.
Confirm DM Cable Type
Confirm DM Cable Type
* Digital Media
Category 6
Category 5e
Next
Cable types that were chosen when output ports were configured (refer to
DM CAT Output Information” on page 171) and selected for testing are
shown with an asterisk (*).
3. If necessary, turn the selection knob to highlight the cable type to be tested
and press the ENTER button to confirm.
NOTE: Selecting a different cable type will cause the other cable types to
be deselected. The parameters of the newly selected cable type will be used
for testing the outputs specified in the next step.
4. Press the soft button labeled Next to continue.
Select Outputs to Test
Select Outputs to Test
* Kid’s Room
* Living Room
* Kitchen
All
None Next
5. Turn the selection knob to highlight an output for testing and press the
ENTER button to mark it. Outputs to be tested are marked with an asterisk
(*).
To test all of the outputs, press the soft button labeled All.