Specifications

DigitalMedia Switchers Crestron DM-MD8X8/16X16/32X32

•

DigitalMedia Switchers: DM-MD8X8/16X16/32X32 Operations Guide – DOC. 6755D

6. To save the Subnet Mask address and return to the Network section, press

the ENTER button. To cancel the operation and return to the Network

section, press the MENU button.

Set the Default Router

DM switchers can be configured to use a Default Router for TCP/IP

communications. To view or set the address of the Default Router:

1. Open the Network section as described on page 44.

2. Turn the selection knob to highlight Default Router and press the ENTER

button to display the address of the Default Router. If DHCP is disabled,

controls for changing the address will be displayed as shown in the

following diagram.

Set Default Router

Edit Default Router

Use Softbutton to select.

The use Knob to edit.

Press ENTER to accept.

[000]

000.

000

3. Press the soft button under the octet to be adjusted.

4. Turn the selection knob to the desired number.

5. Repeat for each octet until the Default Router address is displayed.

6. To save the Default Router address and return to the Network section, press

the ENTER button. To cancel the operation and return to the Network

section, press the MENU button.

DHCP

A DM switcher’s IP address can be obtained from a DHCP server or manually set

using Crestron Toolbox. The default setting for the DHCP mode is “On”. For

information on manually setting the IP address, refer to “IP Address” on page 44

. To

set the DHCP mode:

1. Open the Network section as described on page 44.

2. Turn the selection knob to highlight DHCP and press the ENTER button to

display the DHCP controls.