Installation guide

For details, refer to the latest version of the DM-MD8X8/16X16/32X32
DigitalMedia
™
Switchers Operations Guide, Doc. 6755.
QUICKSTART DOC. 6756D (2022813, 2 of 2) 04.10
3
quickstart guide
DM-MD8X8/16X16/32X32
www.crestron.com
888.273.7876 201.767.3400
©2010 Specifications subject to
change without notice.
DigitalMedia
™
Switchers
All brand names, product names, and trademarks
are the property of their respective owners.
DM-MD8X8/16X16/32X32
7
Apply Power
8
9
A. Connect the AC power cord to the switcher. Then connect the
power cord to AC power.
B. Connect power to any external 24VDC supplies that were
connected in Section 4.
NOTE: The switchers do not have a power switch. Power is
applied to the units by plugging in their respective power cords.
Verify Video Inputs
A. Turn on all available sources.
B. Press the front panel INFO button.
C. Press the applicable front panel IN buttons
to verify the signal type and resolution of each
video input. Typical information displayed is
shown in the illustration below. Use the Selection
Knob to scroll down and view all the information.
INFO
Name: 1
Signal Type: Component
Resolution: 1920x1080
Video Type: Interlaced
Frame Rate: 30fps
Aspect Ratio: 16:9
INFO Button
IN
Source Buttons
Selection Knob
9
9
9
9
9
9
Manual Routing of Input Sources
Front panel controls may be used to route input sources to one or more of the
available outputs.
A. Press ROUTE, then press one or more of the AUDIO, VIDEO, and/or USB
buttons to select the signal type(s) you wish to route.
B. Press the desired input source buttons (IN). The corresponding LED will light. The
LEDs of any outputs the input (or input combination) is currently connected to will also
light.
C. Press one or more of the output buttons (OUT). The corresponding LED(s) will
flash to indicate it is not yet routed.
D. Press the ENTER button to actually route the source; the LED(s) will be on
steady, and the display will show the input type and the outputs to which it is routed.
To disconnect an input source from an output, press ROUTE, then press the desired
output button. The display will show “IN None”. Press ENTER and the output will be
disconnected from the input.
IN
Source Buttons/LEDs
OUT
Output Buttons/LEDs
ENTER
AUDIO
VIDEO
USB
ROUTE