Specifications

6X1 DigitalMedia™ Switcher Crestron DM-MD6X1
Connectors, Controls & Indicators (Continued)
#
CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
20
DM IN 24 A B G
(4-6)
8, 9, 10
(3) 4-pin 3.5 mm detachable terminal blocks,
DMNet ports;
Connects to DMNet ports of DM transmitters
or other DM devices via DM-CBL cable
4
21
DM OUT 24 A B G
8, 9, 10
(1) 4-pin 3.5 mm detachable terminal block,
DMNet port;
Connects to DMNet port of a DM
receiver/room controller, switcher, or other
DM device via DM-CBL cable
4
22
EXT PWR
10
(1) 3-pin 3.5 mm detachable terminal block,
power selection port;
Connects to an external power supply
11
, or
to the internal power source via a jumper, to
power the DM devices connected to
DM IN 4 – 6 and DM OUT;
Maximum Load: 75 Watts
(3.13 Amps @ 24 Volts DC) total for all ports
when connected to external power supply
11
,
otherwise limited to available DMNet power
(refer to “Power Requirements” in the
“Specifications” table which begins on page
6).
23
100-240V ~2.3A
50/60Hz
(1) IEC C14 male chassis plug, main power
input;
Mates with removable power cord, included
24
G
(1) 6-32 screw, chassis ground lug
1. Interface connectors for 24 A B G, EXT PWR, AUDIO IN and AUDIO OUT ports are provided
with the unit.
2. Refer to the following table for the RGB connector pinouts.
PIN # RGB YP
b
P
r
S-VIDEO COMPOSITE
1 R P
r
C
2 G Y Y
3 B P
b
Comp
13 H
14 V
3. The RGB input can accept component, composite and S-video signals via direct interface to Crestron
MPS Series products (sold separately) or through an appropriate adapter (not included). Input sync
detection is not provided for composite or S-video signal types through the RGB connection.
14 • 6X1 DigitalMedia™ Switcher: DM-MD6X1 Operations Guide – DOC. 6850D