Installation guide

DIN Rail 2-Series Automation Processor Crestron DIN-AP2
Hardware Hookup
Connect the
Device
Make the necessary connections as called out in the illustration on the
following page. Refer to “Network Wiring” on page 12 before attaching
the 4-position terminal block connector. Apply power after all
connections have been made.
WARNING: Prior to connecting the device, turn off power at the circuit
breaker. Failure to do so may result in serious personal injury or damage
to the device. Restore power after all connections have been made.
CAUTION: Connecting this device to the wrong type of load, or
short-circuiting the load can cause severe product damage. Each load
should be tested to identify a short circuit condition prior to wiring the
load to the module.
NOTE: Install in accordance with all local and national electric codes.
NOTE: Use copper wire only.
When making connections to the DIN-AP2, use Crestron power supplies
for Crestron equipment.
14 • DIN Rail Automation Processor: DIN-AP2 Operations & Installation Guide – DOC. 6662C