Installation guide

DIN Rail 2-Series Automation Processor Crestron DIN-AP2
Setup
Network Wiring
When wiring the Cresnet
®
and Ethernet network, consider the following:
NOTE: DMNet wiring and Cresnet wiring are not compatible.
Use Crestron Certified Wire.
NOTE:Cresnet-HP wire cannot be used.
Use Crestron power supplies for Crestron equipment.
Provide sufficient power to the system.
CAUTION: Insufficient power can lead to unpredictable results
or damage to the equipment. Please use the Crestron Power
Calculator to help calculate how much power is needed for the
system (www.crestron.com/calculators
).
Cresnet
For networks with 20 or more devices, use a DIN rail Cresnet
Distribution Hub (DIN-HUB) to maintain signal quality.
For more details, refer to “Check Network Wiring” on page 27.
Ethernet
The DIN-AP2 can also use high-speed Ethernet for communications with
other IP-based devices.
For general information on connecting Ethernet devices in a Crestron
system, refer to the latest version of the Crestron e-Control

Reference
Guide (Doc. 6052), which is available from the Crestron Web site
(www.crestron.com/manuals
).
Installation
The DIN-AP2 must be installed by a licensed electrician, in accordance
with all national and local codes.
CAUTION: This equipment is for indoor use only. Mount in a well
ventilated area. The ambient temperature must be 0º to 40º C
(32º to 104º F). The relative humidity must be 10% – 90%
(non-condensing).
12 • DIN Rail Automation Processor: DIN-AP2 Operations & Installation Guide – DOC. 6662C