Installation guide

Crestron DIN-AP2 DIN Rail 2-Series Automation Processor
Connectors, Controls & Indicators (Continued)
# CONNECTORS
1
,
CONTROLS &
INDICATORS
DESCRIPTION
4 MSG LED (1) Red LED, indicates
processor has generated an
error message. To view the
contents of the message log,
use Crestron Toolbox
™
.
5 NET
2
(2) 4-pin 3.5 mm detachable
terminal blocks, paralleled;
Cresnet port and 24 Volt DC
power input;
Master/Slave selectable;
24: Power (24 Volts DC)
Y: Data
Z: Data
G: Ground
Maximum Wire Size: 1.5 mm
2
(16 AWG)
6 HW-R (1) Recessed miniature
pushbutton for hardware reset
(reboots the processor)
7 SW-R (1) Recessed miniature
pushbutton for software reset
(reboots the control system
program)
8 MEMORY (1) MMC compatible card slot;
Accepts Multimedia Memory
Card (MMC) up to 2 GB;
Observe proper orientation of
memory card when inserting
card into MEMORY slot, as
shown on the label adjacent to
the MEMORY slot.
(Continued on following page)
Operations & Installation Guide – DOC. 6662C DIN Rail Automation Processor: DIN-AP2 • 9