System information
Software Crestron D3 Pro
™
each other (click One Horizontal Field). Choose the latter if you want to use
two different fonts within the same line.
D3 Pro will verify that the text will fit within the margins of the button. If the text
does not fit, an error message will be generated.
CNRFHT-30A
The CNRFHT-30A is a hand-held transmitter with up to 30 buttons. It provides the
following options:
Button color - You can change the color of selected buttons as follows:
1. Click each button while pressing the Ctrl key.
2. Right-click and select Button Cap Color from the submenu to open the
color palette.
3. Choose the desired color for the selected button(s).
Button grouping and ungrouping - By default, all 30 buttons on the transmitter are
displayed. Alternatively, you can combine two adjacent buttons to create one longer
button that lies horizontally or vertically:
1. Click each button while pressing the Ctrl key. (You can only group two
buttons at a time. Also, the buttons must be adjacent to each other, either
horizontally or vertically).
2. Right-click and choose Combine Button Caps from the submenu. The new
button will be shown in the selected horizontal or vertical position.
3. To revert back to the two-button setting, right-click the long button and select
Uncombine Button Caps from the submenu.
Showing/Hiding Buttons - By default, all 30 buttons on the transmitter are
displayed. However, you can remove buttons as desired. For example, if your
application requires only 20 buttons, you can remove any 10 buttons from the
transmitter.
To hide buttons
1. Click each button you want to remove while pressing the Ctrl key.
2. Right-click and choose Hide Buttons from the submenu. This will replace
the selected button(s) with engravable areas.
3. You can restore the buttons you removed by right-clicking the transmitter
and selecting Unhide all buttons.
Text area grouping and ungrouping - Just as you can combine two buttons to
create one longer button, you can combine two text areas to form one longer text
field. In addition, you can combine two of these longer text areas to form one long
text field that stretches across the entire row. The engravable text areas are outlined
by dotted rectangles (when you right-click and enable Show Text Area Outlines on
the submenu).
18 • Crestron D3 Pro™ Reference Guide – DOC. 5998a