System information

Crestron D3 Pro
™
Software
CNX AND C2N KEYPADS
Crestron's CNX keypads provide 2, 4, 6, 8, or 12 buttons, while the C2N keypads
come in 6, 8, or 12-button configurations. Only the buttons on the keypads are
engravable.
The CNX keypads also provide you with the option to exclude buttons from your
order. For example, if you only want to engrave six buttons for a CNX-B12 keypad,
you can remove the other six buttons from your order. Simply right-click each button
and choose Exclude Button from Order from the submenu. A red X will cross out
the excluded buttons.
You cannot exclude buttons from the C2N keypads.
CT-1000, LC-1000
AND TPS-2000
The CT-1000, LC-1000, and TPS-2000 touchpanels provide ten engravable buttons,
five on each side of the touchscreen.
The available options for engraving depend on the faceplate/trim combination you
choose. Some combinations provide engravable areas on the faceplate as well as on
the buttons, whereas others only provide engravable areas on the buttons.
ST-1700, STX-1700C
AND TPS-3000L
The ST-1700 and STX-1700C touchpanels provide ten engravable buttons, five on
either side of the touchscreen. The TPS-3000L provides five buttons. On each of
these interfaces only the buttons are engravable, not the faceplate.
To enter text
1. Double-click the button or engravable area you want to engrave.
2. Go to Field One and select a font from the Font list.
You can choose from two fonts: Arial, for readable text; and Crestron
Transport Outline, which consists of symbols that represent standard device
functions such as Fast Forward, Rewind, Volume Up and Volume Down.
Each symbol corresponds to a letter of the alphabet (from A to P, not case
sensitive) as follows:
3. After selecting the font, enter the desired text in the Field One text box.
4. You can click the Field Two check box to enter more text. Here you can
choose a font just as described above.
5. Depending on the interface and the size of the button, you may have the
further option to place Field One on top of Field Two (click Two Horizontal
Fields). In most cases you have the option to place the two fields next to
Reference Guide – DOC. 5998a Crestron D3 Pro™• 17