Specifications

Software Crestron SIMPL Windows
symbol, it is triggered by any change on the analog or serial signal connected to its
"rx$" input.
When a change is detected on the input, the symbol will drive its digital output "out"
high for the amount of time specified in the "pulse_time" parameter. The symbol is
also retriggerable in the sense that if the input signal changes again while the
symbol's output is still high, the timer restarts. Thus the output signal will remain
high until the input stops changing long enough for "pulse_time" to expire. When the
input is an analog signal, any change in value on that signal is enough to trigger the
symbol. When the input signal is a serial signal, the symbol will trigger any time new
data is placed on that signal.
As an example, we can use the Serial/Analog One-Shot symbol to implement
feedback that will blink whenever the volume is changing. Here we must be sure not
to make the pulse_time parameter too short, or the symbol's output may go low for a
short time even while the volume is being adjusted.
Serial/Analog One-Shot Example
press1
press2
press3
press4
press5
press6
press7
press8
press9
press10
press11
press12
PlayingSound
fbck1
fbck2
fbck3
fbck4
fbck5
fbck6
fbck7
fbck8
fbck9
fbck10
fbck11
fbck12
Enable_Temp_Rpt
Temp_Format
Backlite_On
Sound20
CNX-B12
up
down
mute
ramp_time 4s
Analog Ramp
clear
set_all
in1
in2
in3
in4
in5
in6
out1
out2
out3
out4
out5
out6
Interlock
pulse_time
in out
NOT
enable
in1
in2
in3
in4
in5
in6
out1
out2
out3
out4
out5
out6
Buffer
gate out
hi_time 0.1s
lo_time 0.1s
Oscillator
Source_1_select
Source_2_select
Source_3_select
Source_4_select
Source_5_select
Source_6_select
Source_6_select_fb
Source_5_select_fb
Source_4_select_fb
Source_3_select_fb
Source_2_select_fb
Source_1_select_fb
rx$ out
out*
0.1s
Serial/Analog One-Shot
Temp_x10
IndicatorIntensity
BackliteIntensity
AudioVol
aout
62 • Crestron SIMPL Windows Primer – DOC. 6253