Specifications

Power Supply for Crestron Shade Motors Crestron CSA-PWS10S-HUB
Fuse Replacement
CAUTION: For continued protection against risk of fire, replace only with the same type and rating of fuse.
Fuse status is indicated by the green power LED on each associated channel. If the green LED is not illuminated it
means that the fuse needs to be replaced. Fuses are to be serviced only by a trained service person and replaced with
the same type and rating of fuse.
Remove fuse cover from CSA-PWS10S-HUB before servicing. Replace the fuse cover before operation.
Remove Fuse Cover
Uploading and Upgrading
Crestron recommends using the latest programming software and that each device contains the latest firmware to
take advantage of the most recently released features. However, before attempting to upload or upgrade it is
necessary to establish communication. Once communication has been established, files (for example, programs or
firmware) can be transferred to the control system (or device). Finally, program checks can be performed (such as
changing the device ID or creating an IP table) to ensure the device is functioning properly.
NOTE: Crestron software and any files on the website are for authorized Crestron dealers and Crestron Service
Providers (CSPs) only. New users must register to obtain access to certain areas of the site (including the FTP site).
Establishing Communications
Use Crestron Toolbox™ for communicating with the CSA-PWS10S-HUB; refer to the Crestron Toolbox help file
for details. There is a single method of communication: USB.
The COMPUTER port on the CSA-PWS10S-HUB connects to the USB port on the PC via the included Type A to
Type B USB cable:
1. Click Tools | System Info.
2. Click the icon.
Remove the fuse cover
by removing the two
Phillips head screws.
Installation Guide – DOC. 7438C Power Supply for Crestron Shade Motors: CSA-PWS10S-HUB • 13