System information

Reference Guide Crestron 3-Series Control Systems
60 • 3-Series Control Systems Reference Guide – DOC. 7150A
“IP Table Entry” Window
c. In the IP Address/Hostname field, enter the static IP address of the
Ethernet device, or if the device is DHCP-enabled, its fully-qualified
domain name.
d. After entering all of the information, click OK to add the device to the
IP table.
e. Repeat this procedure for all the Ethernet devices in the program.
6. Once all of the devices have been listed, click Send to Device** to upload
the IP table to the control system.
Whenever an IP table is sent to the control system, it overwrites the previously
loaded IP table and reboots the control system.
For Remote Ethernet Processing (Ethernet Slave
Processors)
For information on IP table entries on Ethernet slave processors, refer to “Master-
Slave Mode” on page 30.
For Other Ethernet Enabled Devices
The procedure for setting the IP information is different for each Ethernet enabled
device and is described in each device’s manual.