System information

Reference Guide Crestron 3-Series Control Systems
58 • 3-Series Control Systems Reference Guide – DOC. 7150A
“Device Settings” Window
3. Select the IP ID button and select the hexadecimal IP ID from the list (The
Remap IP ID at program upload option is reserved for future use.)
4. Enter the IP address of the device or click Use Host Name to enter the fully-
qualified domain name of the device and click OK.
5. Repeat for every Ethernet-enabled device in the network.
NOTE: If IP information (IP address/hostname) was not entered for all of
the network devices when creating the program, the default IP table is not
created. The IP table must then be created from Crestron Toolbox. If IP
addresses for the devices are missing, the IP table can be edited from
Crestron Toolbox.
6. After completing the SIMPL Windows logic program, compile and upload
the program. To upload the default IP table to the control system, click Yes
when prompted with the “Confirmation” dialog.
The default IP table is automatically created and uploaded using the IP information
supplied for each network device.
To create a custom IP table with Crestron Toolbox, click No.
Creating and Modifying IP Tables with Crestron
Toolbox
Crestron Toolbox can be used to create and modify a control system’s IP table. Use
Crestron Toolbox to create, modify, or send a control system’s IP table to the control
system without recompiling or transferring a SIMPL Windows program.
1. Open Crestron Toolbox and establish communications with the control
system as described on page 6.
2. Select Funtions | IP Table…. This opens the “IP Table” window.