System information

Crestron 3-Series Control Systems Reference Guide
Reference Guide – DOC. 7150A 3-Series Control Systems • 33
CONNECTFAILEDCOUNT - Set the default slave connect response reject
count. Stops connecting after this number of connect response rejected
No Parameter - Show current connect response reject count
The ETHSLVCONNFCNT command tells the slave after how many unsuccessful
connect attempts to the master should the slave revert back. The default is 100 and
this happens about every 10 seconds. If the count was set to the slave would reset
back in about a minute.
This takes care of a scenario where that particular IP address is UP and running but
does not have a program which listens to that ID.
ETHSLVCONNTIMEOUT
This command sets the default Slave connection timeout setting. If the command is
entered with no parameter it displays the current connect timeout.
ETHSLVCONNTIMEOUT [TIMEOUTINSEC]
TIMEOUTINSEC - Set the default slave connect timeout in seconds. Indicates
the time (in seconds) in which the normal program resumes
No Parameter - Show current slave connect timeout
The ETHSLVCONNTIMEOUT command tells the slave after how many seconds to
wait after being unable to a make a TCP level connections should the slave revert
back to running a program...
This takes care of the case where the slave tries to connect to a non-existant IP
address or to a unit which is not up and running.