Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 96
Appendix F: Music Collection Module v7.1.0
Parameters and I/O
Parameters
Control Protocol Device ID (CPDID)
This must match the CPDID of the component as set through the Kaleidescape
browser interface (http://my-kaleidescape/). None is the default.
When using None, the Crestron processor must be directly connected to the
designated component.
Zone ID
This indicates which zone output to control on the Kaleidescape player.
Collection
The music collection that this module will cycle through. Default collections
include:
 Albums by Artist
 Albums by Title
 Genres (top 40 genres in the music library)
 Mix Albums (user-defined mix albums)
 New (most recently imported albums, the time is defined in the browser
interface)
User-defined collections can also be specified.
Inputs
{{Rx$}} Used for connection to the RX$ signal of the
connected RS-232 port or TCP/IP client.
{{Connect-F}} Resends startup messages to get the module
feedback in sync with the component. If using
TCP/IP, tie this to the Connect-F output of the
TCP/IP client to re-sync the feedback if the
connection cycles. If using RS-232, simply put a 1
on this input.
[First], [Next], [Previous] Play the first, next or previous item in the
collection.
Outputs
{{Tx$}} Used for connection to the TX$ signal of the
connected RS-232 or TCP/IP client.