Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 93
Appendix E: Keypad Presets Module v7.1.0
Parameters and I/O
Parameters
Control Protocol Device ID (CPDID)
This must match the CPDID of the component as set through the Kaleidescape
browser interface (http://my-kaleidescape/). None is the default.
When using None, the Crestron processor must be directly connected to the
designated component.
Zone ID
This indicates which zone output to control on the Kaleidescape player.
Preset ID
A text identifier used for the set of presets. The Preset ID can be unique among all
preset modules, or multiple instances of the module can use the same Preset ID to
manipulate the same set of presets.
Hold Time
This sets the amount of time to hold one of the [Preset#] inputs, must be held in
order to save the preset.
Inputs
{{Rx$}} Used for connection to the RX$ of the connected
RS-232 port or TCP/IP client.
{{Connect-F}} Resends the startup messages to get the module
feedback in sync with the component. If using
TCP/IP, tie this to the Connect-F output of the
TCP/IP client in order to re-sync the-feedback if
the connection cycles. If using RS-232, simply
enter a 1 on this input.
[Play], [Stop], [Pause],
[Fast_Forward], [Rewind],
[Skip_Forward], [Skip_Reverse]
Performs the associated transport action.
[Play-Pause] Performs a play action or pause action
depending on the current playback state. If music
is playing, this input pauses music playback. If
music is stopped or paused, this input resumes
playback.