Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 74
[Mask_Calibrated_Top] and
[Mask_Calibrated_Bottom] values.
[Calibrate_Masking_Overscan]
Causes the OSD to change to the Calibrate Masking
Overscan screen. This screen is used to indicate
the position of the overscan onto the
Kaleidescape movie zone. This overscan data is
used in calculating the
[Mask_Calibrated_Top] and
[Mask_Calibrated_Bottom] values.
Script control
[Play_Script$] Use a Serial I/O (SIO) symbol to send the name
of the script to play to this input. Every time this
text changes, the module sends the command to
play the script. The same script can be triggered
more than once. The name is case sensitive. If
the script name does not exist, a message
appears on the OSD.
[Demo] Plays the script named Demo button, if Demo
button exists. Otherwise, plays all favorite scenes
in order.
[Demo_Loop] Plays the script named Demo button loop, if Demo
button loop exists. Otherwise, plays all favorite
scenes in an infinite loop.
Power
[Power_on] Turns the component on. See Power control on
page 38 for additional notes on this input. While
held high, the module attempts to keep the
component turned on.
[Power_off] Turns the component off. When A/C power is
interrupted, a component always returns to the
last power state. See Power control on page 38
for more information.
[Command_To_Player$] This input can be used to send any arbitrary
command to the component. The module
automatically adds the correct CPDID, sequence
number, and terminating colon and line feed to
any string sent to this input. For example,
attaching a Serial I/O (SIO) symbol to this signal
and sending PLAY would send 03/1/PLAY:\n to
the component with CPDID 03. This input
provides direct access to the control protocol.