Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 66
Appendix C: OSD Module v8.4.0 Parameters
and I/O
Parameters
Control Protocol Device ID (CPDID)
This must match the CPDID of the component as set through the Kaleidescape
browser interface (
http://my-kaleidescape/ ). None is the default.
When using None, the Crestron processor must be directly connected to the
designated component.
Time Update Interval
This indicates whether the component should update the time remaining. If the title
or chapter location, remaining, or level signals are used, this parameter must be set
to 1. If this information is not used, set this parameter to 0 to conserve Crestron
processing.
Using a Controlled Mask
If using an automated screen masking system, set this to 1 (yes) to ensure that
system messages are not shown in the masked area. If using a fixed mask or no
masking, set this to 0 (no) to allow those messages to appear at the top or bottom
of the visible area.
Kaleidescape App for iPad Volume Ability
This indicates which volume buttons and feedback will be displayed on the
Kaleidescape App for iPad when configured without a controller zone name.
Inputs
{{Rx$}} Used for connection to the RX$ of the connected
RS-232 port or TCP/IP client.
{{Connect-F}} Resends the startup messages to get the module
feedback in sync with the component. If using
TCP/IP, tie this to the Connect-F output of the
TCP/IP client in order to re-sync the feedback if
the connection cycles. If using RS-232, simply put
a 1 on this input.
Transports
[Play], [Pause], [Pause_On], [Pause_Off]
Performs the associated transport action.
[Stop] Performs the associated transport action. On
some screens this also acts as [Cancel].