Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 56
2. Connect the [Volume Up], [Volume Down], [Volume Mute] signals on
the output side of the Kaleidescape module to the module of the device
controlling volume.
3. Connect the mute feedback and volume level from the module of the device
controlling volume to [Mute_On_fb] and [Vol_Level] inputs on the
Kaleidescape module. The Kaleidescape App for iPad displays the volume
as a percent. The volume level from the device should be scaled to values
from 0 to 100.
Troubleshooting
User program commands
The following commands can help debug problems in an installation. These
commands must be typed in the Crestron ViewPort or Toolbox Console using the
USERPROGCMD command or the short version, UCMD.
These commands have the following syntax.
USERPROGCMD "<COMMAND>"
UCMD "<COMMAND>"
Where <COMMAND> is one of the following commands. For example,
UCMD "K DEBUG" is the command to enable debugging.
K HELP Shows all the valid K commands. If multiple modules are in
the program, this information displays multiple times.