Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 54
3. Find the [Mask …] output signals in the Masking_Data roll-up. These outputs
go high to indicate the type of picture being shown.
Figure 45: Mask output signals
4. Tie these outputs directly to a Serial I/O symbol to use with the masking
system.
If the projector in this installation used an anamorphic lens, the projector
can be controlled using the anamorphic outputs in the Video_Mode roll-up.
Figure 46: Anamorphic outputs
CinemaScape mask
If CinemaScape mode has been enabled, use the CinemaScape Mask output to
control screen masking. Sample logic has been included in the Kaleidescape OSD
Demo program.
Lighting and shades
In rooms that are primarily for movie watching, for example, the Theater and
Family Room, lights can dim or turn off when the movie starts, brighten or turn on
during intermission, and turn on again at the end credits.
The OSD module provides outputs in the Lighting_Cues roll-up to set this feature.
Figure 47: Lighting Cues
The signals go high for half a second for each of these events. The signals are also
buffered to allow for jamming events together (as shown). For IR controlled lighting
systems, no additional logic is required. Simply tie these signals to the appropriate