Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 52
Programming Kaleidescape modules
Each module must be made unique by modifying the signal names of the sample
modules.
Use the following steps to modify signal names.
1. Select the Bedroom subsystem (music zone 3) and press F9. The Search and
Replace window appears.
Figure 41: Search and Replace window
2. For all the Inputs and Outputs, replace Kaleidescape_ with KMusicZ3_.
3. Click OK.
4. Repeat steps with the Sunroom subsystem (music zone 4) using the name
KMusicZ4_ and also with the Theater (KPlayer3_), Family Room (KPlayer2_) and
Kitchen (KPlayer1_).
5. Open the SATP module for the Bedroom, and scroll to the bottom.
6. Set the Zone ID to 03d (this is the third music zone of the Music Player).
7. Change the List Window Length to 06d (the TPS-4L only supports six lines of
text.
Figure 42: Setting Zone ID and List Window Length
8. Repeat these steps for the Sunroom SATP module using Zone ID 04.
9. Use these same steps to rename the signals of the touch panel modules.