Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 50
10. Click Yes. If a prompt appears to name unconnected signals, click No.
11. Return to the Kaleidescape OSD Demo program and repeat steps 4 through
10 for the remaining input and output signals: digital, analog, and serial.
12. Copy all the signals from the Kitchen TPS-12 that was just created.
a. Select the touch screen symbol in the Program view.
b. Right-click and drag the symbol over the Family Room symbol. A menu appears.
Figure 37: Copy/Move menu
c. Select Copy All Signals/Parameters.
d. Repeat for the Theater touch panel.
The Bedroom and the Sunroom touch panels use the signals from the SATP Demo
program. The procedure is the same except that the SATP Demo program must be
opened to copy the signals from the TPS-15 symbol. Note that the signal set is
different.
When finished copying the signals to either the Bedroom or Sunroom touch panel, use
the right-click technique described above to copy the signals to the other SATP
touch panel.
Adding Kaleidescape modules
Use the following steps to add the sample OSD and SATP modules from the
Kaleidescape Demo programs to the SIMPL program.
1. From the File menu, open the Kaleidescape SATP Demo program.
2. Select the symbol S-1: Kaleidescape SATP v8.4.0 and press Ctrl-C to copy the
symbol.
Figure 38: Copying the SATP Demo module
3. Return to the program and select the Logic folder.
4. Press Ctrl-V twice to paste two copies of the module in the Logic folder. If an
error appears stating Could not paste symbol, verify that the Kaleidescape
Demo programs were imported correctly. See Importing modules on page
22.