Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 48
Programming TCP/IP clients
The communication port must be set and the Connect-F, TX$, and RX$ signals
renamed for each TCP/IP client.
Use the following steps to enter the port number, and name the TX$, RX$, and
Connect-F signals.
1. Click the Program button.
Figure 32: Program button
2. Open the Central Control Modules folder in the Program view.
3. Find the TCP/IP client in the Ethernet slot list.
4. Open each TCP/IP client and set Port to 10000.
5. Set the Connect input to 1.
6. Name the Connect-F, TX$, and RX$ connections. Use the names shown in the
following figure, Kaleidescape_Connect-F, Kaleidescape_TX, and
Kaleidescape_RX, so that the signals correspond to the signals copied and
pasted from the Demo program modules described in the following section.
Figure 33: Naming the Connect-F, TX$, and RX$ signals
Programming touch panels
Copy the signal names from the generic TPS-15 in the Kaleidescape OSD Demo and
Kaleidescape SATP Demo program modules. Then copy the TPS-12 and TPS-15
signals from the OSD Demo program and the TPS-4L signals from the SATP Demo
program.
The signals from the TPS-15 in the Kaleidescape OSD Demo program can be
applied to any touch panel symbol with video capabilities. In this example, the TPS-
15 signals from the OSD Demo program are used for both the TPS-15 and the
TPS-12 touch panels. The signals from the TPS-15 symbol in the Kaleidescape
SATP Demo program are for touch panels controlling music in zones without video
displays.