Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 47
Configuring touch panels
Touch panels must be added to the program and named. The signal names from
the TPS-15 samples in the Kaleidescape OSD Demo and Kaleidescape SATP Demo
programs are copied later.
Use the following steps to add and name touch panels.
1. While still in the Configure view, open the Device Library
Touchpanels/Touchpanels (Cresnet) folder and find the touch panel symbols.
Figure 29: Touch panel symbols
2. Select and drag two TPS-4L, one TPS-12, and two TPS-15 symbols into the
System view.
Figure 30: Selected touch panel symbols
3. Select each icon and rename the touch panels in the same manner as the
TCP/IP clients.
Figure 31: Renamed touch panels