Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 43
http://my-kaleidescape/ (Windows)
http://my-kaleidescape.local/ (Mac)
2. Select the SETTINGS tab.
3. Click on Components in the second row of tabs.
4. Click on the Settings button for the component.
5. Select the NETWORK tab. Information about the current network
configuration for the component is displayed.
Figure 23: Static IP address assignment under the NETWORK tab
6. Select the Use the following IP configuration radio button.
7. Enter a static IP address and related fields.
8. Click OK.
Repeat steps 4 through 8 for each component with a movie or music zone to
control.
Note: Each component with new network settings will have to be restarted
for the settings to take effect.
Configuring TCP/IP clients
TCP/IP clients must be added to the Crestron program. The sample installation
requires two for connecting to music zones 3 and 4 of the Music Player, and three
for connecting to each of the M500 Players controlled from touch panels.
Each of the clients must be named and have an IP address assigned corresponding
to a M500 Player or Music Player. The M500 Player in the Master Bedroom will be
controlled with the IR remote and does not require Crestron programming.
Note: The Kaleidescape sample Crestron programs must be imported
BEFORE continuing. See Importing modules on page 22 for details.
Select
Use the following IP
configuration