Installation guide
Programming Crestron Controllers for a Kaleidescape System
Page 36
Figure 17: OSD music zone control using a CPDID
Serial number control
To select which zone to control using the component serial numbers, setup a Serial
I/O with the serial numbers and Zone ID of the music zones that the OSD is to
control. Figure 18 shows how to use a component serial number to initiate control.
Figure 18: OSD music zone control using a serial number
On the rising edge of the signal Control_1234_zone1, the OSD begins controlling
music of the first zone of the component with serial number 1234. On the rising
edge of the signal Control_1234_zone2, the OSD begins controlling the second
zone of the component with serial number 1234. On the rising edge of
Control_Local, the local movie zone is controlled again. Note that 01 always
refers to the local zone.
To obtain feedback as to which serial number and zone the OSD is currently
controlling, use the Controlling_SN.Zone$ output as shown in the following
figure.