Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 31
Figure 9: CPDID addressing example
Each of the M500 Players is controlled from a Kaleidescape OSD module. The OSD
modules must be configured to match the CPDIDs assigned to the players in the
browser interface. The field for the CPDID is near the bottom of the module.
Figure 10: Configuring the module CPDID
If the controller directs the M500 Player to play a selected movie, the OSD module
sends the following text command to the server:
02/1/PLAY:\r
The server receives the command and reroutes the command to the player with the
CPDID 02 via TCP/IP over Ethernet. The response from the player is directed
through the server back to the OSD module with the CPDID 02.
With the Music Player, a separate SATP or keypad module must be used for each
controlled zone as shown in Figure 11. All SATP and keypad modules for the same
player are assigned the same CPDID (06 in the example) but the Zone ID (01
through 04) must also be set. The SATP and keypad modules send every command
with the CPDID followed by the Zone ID. This identifies each music zone as a
separate, routable endpoint.