Installation guide

Programming Crestron Controllers for a Kaleidescape System
Page 30
Figure 7: Component Settings button
5. Select the CONTROL tab from the Settings page.
6. Select the Control Protocol Device ID (None, 02 through 99) from the drop-
down menu.
Select None only if command routing is NOT used for this device as shown
in the following figure.
Figure 8: Control tab
7.
8. Click OK. The device does not have to be rebooted.
CPDID addressing example
In the example illustrated in Figure 9, a Crestron controller is connected to a 1U
Server either via Ethernet or the RS-232 control port. Unique CPDIDs are assigned
(in the installer pages of the browser interface) to four M500 Players and one Music
Player. The Music Player has four music zones controlled independently with the
addition of Zone IDs. Because the 1U Server connected to the Crestron controller is
the local device, the server uses the default CPDID None. The second 1U Server
does not have to be controlled, so that CPDID is left at the default CPDID None.
Click on Settings
Select None