Installation guide

Crestron CNX-BF12 & CNX-BN12 Function & Numeric Keypads
• Two 1-in. pan head Phillips screws (supplied)
After the Cresnet network wiring has been installed and verified, use the
following procedure to install the keypad in a standard, single-gang
electrical box (refer to illustrations on page 10):
1. Turn Cresnet system power OFF.
2. Connect the Cresnet cable with supplied connector plug to the
keypad’s Cresnet port and the other end to the control system.
3. Remove faceplate and divider from keypad.
4. Make sure button unit is oriented as marked with arrow at top and
place it in the electrical box.
CAUTION: Excess wire that is pinched between the keypad and
electrical box could short out. Make sure that all excess wire is
completely inside the electrical box and not between the box and the
keypad.
5. Attach the keypad to the electrical box using the supplied two 1-in.
pan head screws.
6. Attach faceplate and divider.
7. Turn Cresnet system power ON.
Operations & Installation Guide – DOC. 8185A Function & Numeric Keypads: CNX-BF/BN12 • 9