User Guide

CRESTRON CNWP Wired Panels
REMOTE CONTROL SYSTEMS
1 DOC. 8008D
Specifications subject to change without notice.
DESCRIPTION:
The CNWP series of wired panels, illustrated in figure 1, interfaces with a CRESNET II control system
over the CRESNET II network. The panels use miniature pushbuttons with self-contained feedback LEDs.
Some models include bargraph indicators. The CNWP panels are designed for lectern mounting and are
also available premounted in consolettes with black trim. Custom panel finishes, engraving, colored button
caps, and the omission of unused buttons are all standard.
BAR1 BAR2
MUTE2
@MUTE2
MUTE1
@MUTE1
UP2UP1
DOWN1 DOWN2
1
39
2345
6 7 8 3334353637
38
40
9
47
10 11 12 13
14 15 16 41 42 43 44 45
46
48
17
55
18 19 20 21
22 23 24
49
50 51 52
53
54
56
25
63
26 27 28 29
30 31 32
57
58
59
60
61
62
64
Figure 1. CNWP Series of Wired Panels
Configuration Differences
There are six wired panel configurations available and selection depends on type of installation (lectern or
consolette), number of buttons, and number of bargraphs. A configuration, CNWP, is defined by its suffix.
The number of buttons is identified by a dash and number. A "B" following the button suffix indicates
consolette versus lectern installation. If the suffix contains "BG2" before the button suffix, there are two
bargraphs on the unit. Refer to table 1 for a concise listing of each wired panel configuration.
Table 1. Wired Panel Configurations
CONFIGURATION INSTALLATION BUTTONS BARGRAPHS
CNWP-32 Lectern 32 None
CNWP-64 Lectern 64 None
CNWPBG2-32 Lectern 32 Two
CNWPBG2-64 Lectern 64 Two
CNWP-32B Consolette 32 None
CNWPBG2-32B Consolette 32 Two