Specifications

infiNET™ SWITCHES
for operation of the LED. If the neutral is not
available, the white lead should be capped off.
3. Push all power wires back into the wallbox and
fasten the devices to their respective wallboxes
with the provided screws.
4. Attach decorative faceplates.
5. Restore power at the circuit breaker.
Testing
NOTE: The device may be warm to the touch during
operation. This is normal.
Test the installation by setting the switch’s mode selection
switch (shown in the following diagrams) to the “RUN”
position and perform either of the following steps
(depending on the switch model).
Parts of CLW-SW1RF, -SWS1RF
Button
Mode Selection Switch
RUN
SET OFF
Parts of CLW-SW4RF, -SWS4RF
Button 2
Mode Selection Switch
Button 4Button 3
Button 1
RUN
SET OFF
Testing a -SW1RF and -SWS1RF
With the mode selection switch in the “RUN” position,
tap the top of the button to turn on the load. Tap the
bottom of the button to turn off the load.
For detailed operating instructions, refer to the latest
revision of the infiNET Switches Operations Guide (Doc.
6397) which is available from the Crestron website.
Testing a -SW4RF and -SWS4RF
With the mode selection switch in the “RUN” position,
tap the Button 1 to turn on the load. Tap Button 1 again to
turn off the load.
For detailed operating instructions, refer to the latest
revision of the infiNET Switches Operations Guide (Doc.
6397) which is available from the Crestron website.
Testing a -SLVS1RF
Tap the top of the button to turn on the load. Tap the
bottom of the button to turn off the load. It will emulate
the RUN mode of the -SWS1RF (even if connected to a
-SWS4RF) unless the mode selection switch of the master
is set to “OFF”. For more information, refer to the latest
version of the infiNET Switches Operations Guide (Doc.
6397) which is available from the Crestron website.
infiNET Network
Before an infiNET switch can be used in a controlled
lighting system, it must first be acquired to a
C2N-MNETGW gateway that is connected to a Cresnet
network.
NOTE: The -SW1RF, -SW4RF, -SWS1RF, and
-SWS4RF can also work as stand-alone wall box switches
without being acquired by a C2N-MNETGW.
NOTE: A switch can be acquired to only one gateway.
To acquire a -SW1RF/-SW4RF/-SWS1RF/-SWS4RF to a
C2N-MNETGW, perform the following:
1. Put the C2N-MNETGW in the Acquire mode,
from the unit itself or from Crestron Toolbox™,
as described in the latest revision of the
C2N-MNETGW Operations Guide (Doc. 6317)
which is available from the Crestron website or
the Crestron Toolbox help file.
NOTE: In an environment where multiple
gateways are installed, only one gateway should
be in the Acquire mode at a time.
2. Place the -SW1RF/-SW4RF/-SWS1RF/
-SWS4RF into the Acquire mode by doing the
following:
a. Move the mode selection switch
(located under the LED) to the “OFF”
position.
6 • infiNET™ Wall Box Switch : CLW-SW1/4RF, SWS1/4RF, & SLVS1RF Installation Guide - DOC. 6293C