Specifications

CLW-DIM1, DIMS1, & SLVD1(W/A/B)
Physical Description
Physical view of CLW-SLVD1 (clockwise from top; Top, Side,
and Front)
The -DIM1 and -DIMS1 contain one large pushbutton, a
light emitting diode (LED) with software adjustable
brightness*, and a three-position slider-switch, shown
after this paragraph. The -SLVD1 is similar to the -DIM1
and -DIMS1 but does not have the slider-switch. Line
voltage connections are made at the rear of the dimmer.
Three Class 2 low voltage wires, located on the front of
the switch provide a Cresnet connection to a control
system. The wires are routed to the bottom of the unit for
placement outside of the wall box.
* LED brightness can only be adjusted through Crestron programming
software.
CLW-DIM1/-DIMS1 (L) and CLW-SLVD1 (R) shown in white
1.75 in
(4.45 cm)
3.81 in
(9.68 cm)
4.13 in
(10.48 cm)
3.28 in
(8.32 cm)
1.91 in
(4.85 cm)
2.70 in
(6.86 cm)
1.50 in
(3.81 cm)
The -DIM1, -DIMS1, and -SLVD1 mount in a standard
wallbox and are covered using a decorative faceplate (not
included).
Physical view of CLW-DIM1/-DIMS1 (clockwise from top;
Top, Side, and Front)
Industry Compliance
1.75 in
(4.45 cm)
2.38 in
(6.03 cm)
3.28 in
(8.32 cm)
3.81 in
(9.68 cm)
4.13 in
(10.48 cm)
1.91 in
(4.85 cm)
2.70 in
(6.86 cm)
1.50 in
(3.81 cm)
This unit has been manufactured to comply with UL’s
Standards for Safety in Canada and the United States.
Formal approval is pending.
Important Notes
Read before installation.
• Codes: Install in accordance with all local and
national electrical codes.
Alternate wiring methods may be used for the
Class 2 wiring connection. The 2002 National
Electrical Code (Article 725-55) prohibits Class
2 conductors of the -DIM1, -DIMS1, and
-SLVD1 to occupy the same outlet box as the
power conductors. The exception is Part D of
Section 725.55 of the 2002 National Electrical
Code, which allows a device’s power conductors
to be installed near (0.25 inch minimum spacing)
associated Class 2 conductors in the same outlet
box. Consult the 2002 National Electrical Code
Handbook and your local electrical inspector
before proceeding.
Do not use the supplied butt-splice connectors if
the Class 2 conductors are to be installed in the
wallbox with the power conductors. Use
approved connectors (supplied by others) to
make Class 2 connections inside the wallbox.
2 • Stand Alone Wall Box Dimmer : CLW-DIM1, DIMS1, & SLVD1 Installation Guide – DOC. 6250