Specifications
iLux
™
Lighting Systems
5. Connect each load wire to the corresponding
LOAD terminals on the unit, connect the power
T line hot wire from the circuit breaker to the HO
terminal on the unit, connect all neutral wires to
the NEUTRAL terminal on the unit, and connect
all ground wires to the
(ground) terminal on
the unit.
If Cresnet cabling is part of the installation,
attach the
6.
supplied terminal block connector(s)
t
7. all wires into the wallbox and
8. to the front
ng
ng
to the Cresnet cable(s) and plug into the
appropriate port(s) on the unit. Make certain tha
there is a minimum 1/4-inch (0.6 cm) separation
between the Class 2 Cresnet wiring and the Class
1 AC wiring.
Carefully tuck
fasten the unit to the wallbox using the four
7/8-inch Phillips screws supplied.
Reattach the control panel overlay
panel by inserting the four tabs into the slots
provided, and install the hinged front cover
assembly by lining it up at the top and pressi
the bottom edge until it snaps into position.
lining it up at the top and pressi
the bottom edge until it snaps into position.
Power up and Testing Power up and Testing
The following illustration shows the front panel of the
Front Panel Controls and Indicators
unit and the controls used during installation.
^
^
Scene 1 Scene 2 Scene 3 Scene 4 Scene 5 Scene 6
^
^
Min
Sec
Lights
Shades
Save
Cancel
1
2
3456
ON
OFF
Bargraphs
Two-Digit
Display
Function
Buttons
LED
basic installation and wiring connections as
follo
1.
onding LED
2.
king it safe to service the
lighting installations.
Verify the
ws:
Press the Lights button to enable manual light
control, and press the right side and the left side
of each of the function buttons to increase and
decrease the lighting level of those loads. Verify
that the intended loads and corresp
bargraphs respond appropriately.
Press the OFF button to turn off all loads. The
loads will ramp down to off while the two-digit
display counts down to off (blank). Two seconds
after all lights have turned off, the unit’s master
air-gap relay opens ma
Installation Guide – DOC. 6413B iLux
™
Lighting Systems: CLSI-C6 & CLSI-C6M • 3