Crestron CLS-C6 Series iLux® Integrated Lighting System User Guide .
Contents iLux® Integrated Lighting System: CLS-C6 Series 1 Introduction................................................................................................................................1 Operating Modes........................................................................................................................5 Standard Mode.............................................................................................................5 Lights Mode.....................................
iLux® Integrated Lighting System Crestron CLS-C6 Series ® iLux Integrated Lighting System: CLS-C6 Series Introduction The CLS-C6 series of iLux® units are complete, integrated wall-mounted lighting system that can function as standalone devices and/or be part of a Crestron® solution total control system network. The units are intended for installation in boardrooms, auditoriums, home theaters, or anywhere versatile and cost-effective control of lighting and shades is required.
iLux® Integrated Lighting System Crestron CLS-C6 Series CLS-C6 Model Definition MODEL POWER REQUIREMENTS DESIGNATION 120 VAC CLS-C6 X CLS-C6M X 230 VAC X CLSI-C6M X X CLS-C6MRF X DETECTOR CONTROL SYSTEM INTEGRATION Cresnet® infiNET™ X CLSI-C6 CLS-C6RF MOTION X X X X X X CLSI-C6RF X CLSI-C6MRF X X X X X X All controls and indicators for the CLS-C6 are located on the front of the unit.
iLux® Integrated Lighting System Crestron CLS-C6 Series CLS-C6 Controls & Indicators Bar Graphs IR Receiver Function Buttons and LEDs Two-Digit Display Motion Detector (CLS-CLSI-C6MRF only) Label Strip Mini Phone Jack Up/Down Button The table below and on the following page describes the function of the iLux unit’s controls and indicators, which are listed in alphabetical order.
iLux® Integrated Lighting System Crestron CLS-C6 Series CLS-C6 Controls & Indicators Descriptions (Continued) CONTROLS & INDICATORS DESCRIPTION IR Receiver The IR receiver responds to commands from an optional remote control. Label Strip The label strip identifies the use of the function buttons. The illustration shows the default purpose: selection of the first six scenes. The label in your unit may be different, depending on the unit’s configuration and lighting/shades arrangement.
iLux® Integrated Lighting System Crestron CLS-C6 Series Operating Modes After installation, the CLS-C6 operates in one of three modes: • Standard mode: this is the default mode; buttons are typically used to recall scenes, although they can be reprogrammed by the dealer for other functions. • Lights mode: this mode is used to manually adjust lighting loads. • Shades mode: this mode is used to manually control shade groups.
iLux® Integrated Lighting System Crestron CLS-C6 Series To exit Lights mode, press the Lights button again, or press Cancel. The LED will go off, and the unit will revert to Standard mode. Shades Mode Shades mode allows you to manually adjust any of the six shade groups. To enter Shades mode, press the Shades button. The LED will light, and the six function buttons can now be used to adjust shade groups 1 through 6.
iLux® Integrated Lighting System Crestron CLS-C6 Series Changing Scene Presets Scene Presets With Daylight Harvesting If a photocell is present, Scenes 1 through 8 (plus the ON scene) will automatically utilize Daylight Harvesting. When this automatic behavior is enabled, the top bar graph LED for that load will blink. NOTE: When editing scenes with photocell-controlled loads, photocell output will be temporarily disabled.
iLux® Integrated Lighting System Crestron CLS-C6 Series Problem Solving Troubleshooting The table below provides corrective action for possible trouble situations. If further assistance is required, please contact your dealer. CLS-C6 Troubleshooting TROUBLE The unit does not respond as expected after changing preset. POSSIBLE CAUSE(S) Incorrect procedures were used to change the preset. CORRECTIVE ACTION Refer to “Changing Scene Presets” on page 7 to revise the preset correctly.
Crestron CLS-C6 Series iLux® Integrated Lighting System This page is intentionally left blank. User Guide - DOC.
Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com User Guide – DOC. 6395C (2014521) 05.11 Specifications subject to change without notice.
