Specifications

iLux Lighting Systems

4 • iLux Lighting Systems: CLS-C6 & CLS-C6M Installation Guide – DOC. 6394F

CLS-C6M Installation

3. Remove the control panel overlay from the unit (it is held in place by small tabs and lifts off) to reveal the

upper mounting screw holes.

4. Refer to the diagram below for connection of the ac wiring. All wires to be inserted in the screw terminals

ould be

stripped 7/16 inch (~11 mm), and screws should be tightened to between 8 and 10 in.-lbs.

(0.90 to 1.13 Newton meters). The maximum wire size is 12 AWG (3 mm

5. Connect each load wire to the corresponding LOAD terminals on the unit, connect the power line hot wire

from the circuit breaker to the HOT terminal on the unit, connect all neutral wires to the NEUTRAL

terminal on the unit, and connect all ground wires to the (ground) terminal on the unit.

6. If Cresnet cabling is part of the installation, attach the supplied terminal block connector(s) to the Cresnet

cable(s) and plug into the appropriate port(s) on the unit. Make certain that there is a minimum 1/4 inch

(~6 mm) separation between the Class 2 Cresnet wiring and the Class 1 ac wiring.

7. Ca

fully tuck all wires into the electrical box and fasten the unit to the electrical box using the four

7/8-inch (~22 mm) Phillips screws supplied.

8. Reattach the control panel overlay to the front panel by inserting the four tabs into the slots on the unit, and

install the hinged front cover assembly by lining it up at the top and pressing the bottom edge until it snaps

into position.

CLS-C6M AC Wiring

1. Use a 15 or 20 A circuit breaker depending on installation requirements. Refer to specifications for load rating details.

2. CLS-EXP expansion modules can be used in place of any or all loads shown above. Refer to expansion module documentation for wiring details.

4-Gang Electrical

Box

Mounting Screws (4)

Front Cover Assembly

Control Panel Overlay

Load

Hot

Neutral

Distribution

Panel

Load

Circuit

Breaker

Standard Cresnet Wiring

–

Red

–

White

–

Blue

–

Black