Specifications

iLux Lighting Systems
12 • iLux Lighting Systems: CLS-C6 & CLS-C6M Installation Guide – DOC. 6394F
Strip and Tin Wire
When daisy chaining Cresnet units, strip the ends of the wires carefully to avoid nicking the conductors. Twist
together the ends of the wires that share a pin on the network connector and tin the twisted connection. Apply solder
only to the ends of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle. Insert the tinned
connection into the Cresnet connector and tighten the retaining screw. Repeat the procedure for the other three
conductors.
Add Hubs
Use of a Cresnet Hub/Repeater (CNXHUB) is advised whenever the number of Cresnet devices on a network
exceeds 20 or when the combined total length of Cresnet cable exceeds 3000 feet (914 meters).
Further Inquiries
To locate specific information or resolve questions after reviewing this guide, contact Crestron's True Blue Support
at 1-888-CRESTRON [1-888-273-7876] or refer to the listing of Crestron worldwide offices on the Crestron Web
site (
www.crestron.com/offices) for assistance within a particular geographic region.
To post a question about Crestron products, log onto the Online Help section of the Crestron Web site
(
www.crestron.com/onlinehelp). First-time users must establish a user account to fully benefit from all available
features.
Future Updates
As Crestron improves functions, adds new features and extends the capabilities of the CLS-C6 and CLS-C6M,
additional information may be made available as manual updates. These updates are solely electronic and serve as
intermediary supplements prior to the release of a complete technical documentation revision.
Check the Crestron Web site periodically for manual update availability and its relevance. Updates are identified as
an “Addendum” in the Download column.