Specifications

Crestron CLS-EXP-DIMFLV iLux Dimmer Expansion Module
6
•
iLux 0-10V Fluorescent Dimmer Expansion Module: CLS-EXP-DIMFLV Installation Guide – DOC. 6680B
Hardware Hookup
WARNING: RISK OF SERIOUS PERSONAL
INJURY. Turn off power at the circuit breaker(s) prior to
installation. Installing with power on can result in serious
personal injury and damage to the device.
1. Use a #2 Phillips screwdriver to remove the cover
screws as shown in the following diagram and
remove the cover.
Remove Cover Screws
2. Depending on the module’s application, select the
appropriate configuration from one of the wiring
diagrams in the next column and connect the
CLS-C6 and load(s) as shown.
• Wires should be stripped to 7/16 in (12 mm).
• Tighten terminal screws to 7 in-lbs (0.79 Nm).
• When wiring a 0-10 V fluorescent dimmer, the
+ and – terminals can be wired as Class 1 or
Class 2. If wired as Class 1, the barrier
between the NEUT and + terminals can be
removed.
NOTE: Dimmer channels controlling one or more
CLS-EXP-DIMFLV modules must not be wired to
control any other type of load.
NOTE: While these diagrams show a CLS-C6 as
the controlling source, other Crestron products
such as CLW-Series wall dimmers (Cresnet
®
and
infiNET™) and CLX-Series dimming modules can
be used as well. Refer to “Specifications” on page
1
for details.
NOTE: When using a CLW-Series wall dimmer,
the wall dimmer must be wired with a dedicated
neutral wire.
CLS-EXP-DIMFLV Wiring for 0-10 V Dimming
CLS-EXP-DIMFLV Wiring for Switching Application
3. Apply power to the line or load and turn on the
controlling device. The power indicator LED
lights indicating that power is supplied to the
module.
4. Replace the cover and cover screws.
Cover
Screws
Neutral
CLS(I)-C6
LOAD3
LOAD2
LOAD1
HOT
NEUTRAL
Neutral
Hot
(120 or 230 Vac )
Hot
(120 to 277 Vac )
Black
Violet
Gray
Black
White
0-10V Fluorescent
Dimming Ballast
Neutral
CLS(I)-C6
LOAD3
LOAD2
LOAD1
HOT
NEUTRAL
NEUTRAL
Hot
(120 to 277 Vac)
Black
Black
White
Switched Load