Specifications

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M iLux Integrated Lighting System
Operations Guide – DOC. 6347G iLux Integrated Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 75
FUNCTION
NAME
MASTER LOWER LIGHTING LOADS (LAST SCENE,
ALL LIGHTS, ON SCENE, SCENES 1–15)
Behavior Same as Lower Lighting Load, except acts on all dimmable
Lighting Loads affected by the specified scene. All lights
ramp at the same rate.
Non-dim loads are not affected.
Shades are not affected.
LED On while button is pressed
Applies To Standard Rocker, Shifted Rocker, Remote Button
Rocker Behavior Left, right, and center all perform the same function.
Notes N/A
FUNCTION
NAME
MASTER RAISE/LOWER LIGHTING LOADS (LAST
SCENE, ALL LIGHTS, ON SCENE, SCENES 1–15)
Behavior Pressing left side of button act same as Master Lower
Lighting Loads. Pressing right side of button act same as
Master Raise Lighting Loads.
For up/down button:
bottom button = left button => lower.
top button = right button => raise.
LED On while button is pressed
Applies To Standard Rocker, Shifted Rocker, up/down (Last Scene and
All Lights only)
Rocker Behavior As specified under “Behavior”
Notes N/A
FUNCTION
NAME
TOGGLE-DIM SCENE (ON, 1–15)
Behavior Similar to the “Toggle Scene” function, except that a
maintained press of the button causes the lights to enter
“cycle-dim” mode. That is, all lights programmed in the
specified scene either raise or lower until the button is
released. (Behavior is the same as Raise Scene function.) A
subsequent maintained button press causes the lights to dim
in the opposite direction.
If the button is tapped instead of held down, it behaves
identically to the “Toggle Scene” function.
LED On when any light in scene is on
Applies To Remote Button
Rocker Behavior N/A
Notes This function intended for use only on scenes that do not
affect shades.