Specifications

iLux Integrated Lighting System Crestron CLS/CLSI-C6 & CLS/CLSI-C6M
74 • iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M Operations Guide – DOC. 6347G
FUNCTION
NAME
LOWER LIGHTING LOAD (1–6)
Behavior Specified lighting load lower as long as button is held. It
stops when button is released. Rate is the global ramp rate.
If loads hit the low-end limit, the bar graph continues to go
down, but lights stays at low-end limit level until reach
OFF—at which point they turn off.
If starting from above the high-end limit, the bar graph starts
to go down, but lights stay at high-end limit level until display
reaches the high-end limit. Then the light and bar graph start
moving in sync.
For non-dim load, lights immediately go to full off.
LED On while button is pressed
Applies To Remote Button
Rocker Behavior N/A
Notes This is same as pressing the left side of front panel function
button when in Lights Mode.
FUNCTION
NAME
RAISE/LOWER LIGHTING LOAD (1–6)
Behavior Pressing left side of button acts the same as Lower Lighting
Load. Pressing right side of button acts the same as Raise
Lighting Load.
LED On while left or right button is pressed
Applies To Shifted Rocker
Rocker Behavior Described in Behavior
Notes N/A
FUNCTION
NAME
MASTER RAISE LIGHTING LOADS (LAST SCENE,
ALL LIGHTS, ON SCENE, SCENES 1–15)
Behavior Same as Raise Lighting Load, except acts on all dimmable
Lighting Loads affected by specified scene. All lights ramp at
the same rate.
Non-dim loads are not affected.
Shades are not affected.
LED On while button is pressed
Applies To Standard Rocker, Shifted Rocker, Remote Button
Rocker Behavior Left, right, and center all perform the same function.
Notes N/A