Specifications

iLux Integrated Lighting System Crestron CLS/CLSI-C6 & CLS/CLSI-C6M
72 • iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M Operations Guide – DOC. 6347G
Appendix E: Button Functions
Following is a list of button functions, in table format, one function per table. Each
table lists “Behavior,” “LED action,” “Applies to”, “Rocker behavior,” and “Notes.”
Some topics may not apply to certain button types; this is defined in the “Applies to”
row.
There are four classes of buttons to be considered:
• Standard Rocker - the six function buttons on the front panel of the CLS-C6,
while the CLS-C6 is in Standard mode and the shift flag is not set.
• Shifted Rocker - the same physical buttons as the standard rocker, but are
active when the shift flag is set.
• Up/Down Rocker - this is the vertical button on the face of the CLS-C6.
• Remote Button - the single-action (i.e., non-rocker) buttons located on remote
keypads.
FUNCTION
NAME
RECALL SCENE (OFF, ON, 1–15)
Behavior Fades specified lights to specified levels in the specified
time. (Non-dim loads switch at the beginning or end of the
specified time, as determined by the Load Type option for
each load.)
Also, sends specified shades to specified positions (the time
is determined by the motor).
Note that the off scene is special in that it cannot specify
which lighting loads are affected or what their target levels
should be—all lighting loads go to full off (definitely causing
air-gap relay to open). Fade time and shade behavior can
still be specified.
LED action Flash while lights are actively fading, Scene-interlocked*
afterwards. (Note that for Recall Off Scene, LED is on when
all lights are off.)
*LED goes on when scene is recalled. LED remains on until
another scene is recalled (or Lights_in_Scenex_Off is
executed) which has overlapping lighting load or shade
group programming. That is, a scene which affects at least
one common lighting load or shade group.
Applies to Standard Rocker, Shifted Rocker, Remote Button
Rocker behavior If the “Enable Raise/Lower on Scene Recall Buttons” option
is set in iLux Designer, the right and left rockers perform
“Scene Raise” and “Scene Lower” functions if, and only if,
the scene feedback LED for that button is lit.
If the “Enable Raise/Lower on Scene Recall Buttons” option
is not set, then the right, left, and center press all perform the
same function.
Notes
The ON and OFF buttons always recall the On and Off
scenes, respectively. The assigned functions cannot be
changed.