Specifications

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M iLux Integrated Lighting System
Operations Guide – DOC. 6347G iLux Integrated Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 27
IR Reception
1. At the “iLux>” prompt, type IR and press Return to display the current
setting. The system displays the following:
IR reception is enabled (or disabled)
iLux>
2. To disable IR reception, type IR disable and press Return. The system
displays the following:
IR reception is disabled
iLux>
3. To enable IR reception, type IR enable and press Return. The system
displays the following:
IR reception is enabled
iLux>
LED Brightness
These settings are for the white LEDs next to the function buttons, the ON button,
the shift LEDs, and the green bar graph LEDs.
1. At the prompt, type WHITELEDLEVEL or GREENLEDLEVEL and press
Return. For example, the system displays the following:
White led brightness level = 70
iLux>
2. To change the brightness, type WHITELEDLEVEL ## or
GREENLEDLEVEL ## where “##” is any number from 1 to 100.
3. Press Return; the respective LEDs go to their new level.
Glow Mode Brightness
Glow mode is enabled when all lighting loads are turned off. In Glow mode, all the
white LEDs turn on at a very low level to make it possible to find the unit in a
darkened room.
1. Press the OFF button to select the Off scene (all lights off).
2. At the prompt, type WHITELEDGLOWLEVEL and press Return. The
system displays the following:
White led glow level = 7
iLux>
3. To change the brightness, type WHITELEDGLOWLEVEL ## where “##” is
any number from 1 to 100. (The glow level should be much lower than the
normal LED brightness.)
4. Press Return; the white LEDs go to their new level.
Replacing the Function Button Label
Each CLS-C6 is supplied with a pre-printed label sheet in white, almond, or black to
match the unit’s color. The sheet contains two labels showing the standard Scene 1
through Scene 6 button labels, three labels with clear spaces that permit writing in
single line button names, and three labels with clear spaces that permit writing in
2-line button names to accommodate shift functions. The label sheet is