Specifications

iLux Integrated Lighting System Crestron CLS/CLSI-C6 & CLS/CLSI-C6M
26 • iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M Operations Guide – DOC. 6347G
CLS-C6
The "CLS-C6" screen allows entry of the manual ramp rate used by the CLS-C6
when manually raising/lowering light levels, defines the functionality of the six
function buttons, defines the behavior of the up/down button, specifies if scene
raise/lower is enabled, and defines the entry action, the exit action, and motion
sensor timeout when the motion sensor function is enabled. Crestron Engraver
software can also be launched to create an engraver project for the CLS-C6RF label.
NOTE: In systems with multiple CLS-C6 units that have the motion sensor function
enabled, it is important to set the motion sensor timeout of each unit to the same
value.
Keypads
The "Keypads" screen allows up to 16 remote keypads to be added, specifies the
remote keypad type, and defines the action type, action, and target of each button on
that keypad. Crestron Engraver can also be launched to create an engraver project for
each remote keypad.
NOTE: All keypads defined in the project must be installed and present on the
CLS-C6 network before setting Network IDs via the “Finish” screen.
Touchpanel
The "Touchpanel" screen allows up to two touch screens to be added. Unique names
for the touch screen and buttons can be added and the action type, action, and target
of each button on that touch screen can be defined.
NOTE: All touch screens defined in the project must be installed and present on the
CLS-C6 network before sending touch screen projects or setting Network IDs via the
“Finish” screen.
Finish
From the “Finish” screen, projects can be sent from the iLux Designer to the
CLS-C6; Net IDs can be set for network devices; configuration information can be
retrieved from the current CLS-C6 module; and reports that give the spreadsheet data
from each of the configuration screens can be printed.
Console Command Settings
Enabling/disabling IR reception, resetting the brightness level for the white and
green LEDs, and resetting the Glow mode level can be done only via console
commands.
By default, IR reception is enabled, the white and green LED brightness levels are
set to 70 and 63, respectively, the white shift LED brightness level is set to 70, and
the white LED Glow mode level is set to 7. If the settings are acceptable, continue
with the configuring procedures. If these settings are not satisfactory, open the
Crestron Toolbox and click Tools | Text Console to display the “Text Console”
window and follow the instructions given on the following page.