Specifications

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M iLux Integrated Lighting System
Operations Guide – DOC. 6347G iLux Integrated Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 21
NOTE: Crestron drapery track controllers are also configured during the
“Assign Shade Groups” process. Drapery track controller setup and
functionality is identical to the setup of shades.
• While in the “AS” option, the bar graphs indicate the status of each of the
six shade groups:
⇒ No controllers are assigned, all LEDs remain off
⇒ C2N-SDC controller(s) are assigned, the bottom two LEDs light
⇒ C2N-SDC-DC controller(s) are assigned, the bottom three LEDs light
⇒ C2N-SSC-2 controller(s) are assigned, the top two LEDs light
⇒ CSC-DCCN controller(s) are assigned, the top three LEDs light
⇒ CSC-ACCN controller(s) are assigned, the top four LEDs light
⇒ CSC-DRPCN controller(s) are assigned, the top five LEDs light
⇒ CSM-QMT50 controller(s) are assigned, the top three LEDs light
• When a given “AS / #” is displayed, press the channel 1 or channel 2 up or
down button on a shade controller to assign that channel of the shade
controller to the current group. When the button is pressed, the Setup LED
on that device flashes for 1 second to confirm that it has been assigned. The
bar graph for that group also blinks off for 1 second.
• Go to a shade group and assign all channels. Then go to the next shade
group and assign those channels. Repeat for all shade groups.
NOTE: A given shade group can only have one type of shade controller
(C2N-SDC, C2N-SDC-DC, C2N-SSC-2, CSC-DCCN, CSC-ACCN,
CSC-DRPCN, or CSM-QMT50). If a shade controller of a given type is
assigned to a group that already contains shade controllers of the other type,
the other controllers are removed from that group. Also, a given channel on
a shade controller can only belong to a single group. So if a shade controller
that belongs to one group is assigned to a new group, it is removed from the
first group. Therefore, if a shade controller is accidentally configured to the
wrong group go to the correct group and reassign it.
Once all shade controllers are assigned, press Save to save the assignments and
return to Standard mode or press Cancel to discard the assignments.
Set Cresnet ID of This Unit (id)
If this unit is to be connected to a Cresnet control system network, the Cresnet ID
may have to be changed. (When connected to another CLS-C6 unit’s local network,
do not set the ID; running auto-discovery on the master device performs this
automatically, as will the Set ID process of the iLux Designer.)
1. Enter Setup mode and scroll to the “id” option, using the and buttons.
2. The display alternates between “id” and the current Cresnet ID. Use the
up/down button to adjust the ID up or down (03-FE).
3. Press the Save button to save the new value and return to Standard mode.
Press the Cancel button to return to Standard mode without saving; the
current Cresnet ID is retained.