Specifications

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M iLux Integrated Lighting System
Operations Guide – DOC. 6347G iLux Integrated Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 17
Setup High-End Levels (HE)
This option allows setting of the full on level of the lighting loads below their
maximum brightness. To set the high-end levels for the six lighting loads, see below:
• Enter Setup mode and scroll to the “HE” option (using the and
buttons). At this point the lights do not change but the bar graphs
immediately indicate the high-end levels for each lighting load. (In most
cases this is 100%, which is indicated by all bar graph segments being on.)
• To set the high-end level, use the rocker button corresponding to that
lighting load to adjust it up or down. When the first adjustment is made, the
light being adjusted jumps to the current high-end level; start adjusting from
there. As adjustments are made, the current light level for the lighting load
being adjusted should appear in the bar graph and the 2-digit display.
• The high-end level cannot be adjusted below 67%.
NOTE: For non-dim and unused lighting loads, the high-end level cannot
be adjusted (always at 100%). If adjusting this, the light and bar graph do
not change, and the 2-digit display shows “Er” to indicate an error.
If setup is exited without pressing the Save button, the original values are retained.
For lighting loads where adjustments have been made, lights jump to the original
high-end level. Light levels are not changed on lighting loads where no adjustment
was made. When the Save button is pressed, Setup mode is exited, the new values
are saved, and the lights do not change.
Setup Button Functions (bF)
This setup option is used to define the behavior of the buttons on the CLS-C6 unit
and on remote keypads if operation is desired other than the default. (Remote
keypads must be ID’d, using auto-discovery, prior to this, which sets them to their
default functions.) To enter this mode, do the following:
• First enter Setup mode and scroll to the “bF” option (using the and
buttons). Then use the up/down button to scroll through the available button
functions and values. This scrolls through all values for each function
before proceeding to the next function.
• Press and hold the button to auto-repeat. During auto-repeat, when the
minimum or maximum value for that function is reached, it stops. The next
button push then increments/decrements to the next function.
Available functions and values are as shown in the following table. (Other
functions require a PC with iLux Designer software to configure them.)
BUTTON FUNCTION CODE POSSIBLE VALUES
Recall Scene F1 oF,on,1–15
Toggle Scene F2 on,1–15
Control Shade
(open/stop/close/stop)
F3 AL, 1–6
Master Raise/Lower (last scene) F4 uP, dn, ud (rockers only)
1. To assign a function to a certain button or buttons, first scroll to the
desired function and value. Then, press each appropriate function
button or remote button to assign the displayed function and value to