Specifications

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M iLux Integrated Lighting System
Operations Guide – DOC. 6347G iLux Integrated Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 13
light (and the display shows “– –”) to indicate that the level of the lighting
load does not change when that scene is recalled.
5. To change the shade presets for that scene press the Shades button; the
Shades LED lights.
6. Use the six function buttons to adjust the levels of the shade groups for that
scene. Press the right side to raise the shades; press the left side to lower
them. While the shades are moving, press any part of the button to stop.
Note that for shades that are not capable of being preset, only full open or
full closed positions can be recalled as part of a scene.
7. If there should be a certain shade group to be unaffected by that scene
recall, press and hold the center of the button (so both sides make contact)
for 3 seconds. The top and bottom two LEDs of the associated bar graph
light (and the display shows “– –”) to indicate that the level of that shade
group does not change when that scene is recalled.
8. To adjust the fade time, press the and buttons. When increasing the
time, the value goes from 0 seconds to 59 seconds, and then 1 minute to 99
minutes. When decreasing the time, the value goes from 99 minutes to 1
minute, and then 59 seconds to 0 seconds. The Min and Sec LEDs light as
appropriate. Adjustment to fade time can be made when either Lights mode
or Shades mode is active.
9. When all the lighting loads are at the desired level and shades are at the
desired position, press Save to save these settings as the new preset for that
scene. If a mistake is made while changing a setting, press Cancel to
discard changes and return to Standard mode before pressing Save.
10. Repeat the above procedures for all scenes that require changes.
Setup Mode
Setup mode is used to change internal settings on the CLS-C6, including the scene
presets as discussed in the previous paragraph.
• To enter Setup mode
, press and hold the Save and Cancel buttons for 5
seconds. The Cancel LED blinks and the first setup option (“Sc”) displays
to indicate that the unit is now in Setup mode.
NOTE: While scrolling through the list of setup options, before an option
is locked, the Save button is not functional and its LED is off. However, the
Cancel LED blinks since the button can be pressed to return the unit to
Standard mode.
• If the unit is connected to a Cresnet control system, Setup mode cannot be
entered to adjust scene settings. The 2-digit display indicates “Er” (error).
• When the unit is in Setup mode, the 2-digit display uses a 2-character
mnemonic to indicate which specific aspect of the CLS-C6 is changed. As
these are being adjusted, the display may indicate values. The following is a
list of the different setup options and the corresponding mnemonic codes.