Installation guide

Crestron CEN-WAP-ABG 802.11a/b/g Wireless Access Points
Bridge Mode
This useful feature allows a CEN-WAP-ABG to be used to add wireless connectivity
to any device with an Ethernet port, or to extend a LAN via a wireless link whenever
a CAT5 wire cannot be run.
Ethernet Pass-Through (CEN-WAP-ABG-1G only)
An Ethernet port is available on the front of the CEN-WAP-ABG-1G, providing a
convenient LAN connection for computers and touchpanels. This port can be
disabled via software if not required.
Specifications
Specifications for a CEN-WAP-ABG are listed in the following table.
CEN-WAP-ABG Specifications
SPECIFICATION DETAILS
RF Wireless
RF Transceiver
IEEE 802.11a/b/g; 5.8 or 2.4 GHz 2-way RF;
64, 128, and 152-bit WEP encryption; WPA
and WAP2 with TKIP and AES
Transmit Power Up to 19 dBm
Range
30 feet (10 meters); range and speed vary
based upon environmental conditions
Ethernet
10BaseT/100BaseTX, auto-switching, auto-
negotiating, auto-discovery, full/half duplex,
TCP/IP, UDP/IP, DHCP client and server,
SNMP, IEEE 802.3u and 802.3af compliant
Power Requirements
IEEE 802.3af Power over Ethernet, 3.3 W
(70 mA) @ 48 VDC
Environmental
Temperature 32º to 104º F (0º to 40º C)
Humidity 10% to 90% RH (non-condensing)
Heat Dissipation 11 BTU/Hr
Enclosure Injection-molded plastic, white textured finish
CEN-WAP-ABG-1G: Wall mountable using
a 1-gang plaster ring (recommended) or
electrical box (2.5 inch deep minimum), rack
mountable using a third-party rack mount
panel*; requires Decora faceplate (not
included)
CEN-WAP-ABG-CM: Ceiling mountable
using a 1-gang plaster ring (recommended)
or electrical box (2 inch deep minimum),
removable and paintable cover
(Continued on following page)
Operations & Installation Guide – DOC. 6695C 802.11a/b/g Wireless Access Points: CEN-WAP-ABG • 3